GeeXboX

Lirc KO on cubox i pro 4

January 12th, 2015

Home › Forums › GeeXboX on ARM SoCs › Lirc KO on cubox i pro 4

This topic contains 3 replies, has 2 voices, and was last updated by droop 1 day, 16 hours ago.

Viewing 4 posts – 1 through 4 (of 4 total)
  • Author
    Posts
  • January 12, 2015 at 11:54 #9568

    droop
    Member

    Hello,

    I had a old build (july 2104) of geexbox, I succeeded in configuration with 2 of my remotes.
    (modification of “hardware.conf” and “mycustom.conf”. It was working perfectly.

    Now with same files, I can see the service is running with the good parameters and config files, but nothing happens.
    Even if I try to see IR input with irw or irrecord, nothing happens.

    Hardware is Cubox-i pro 4.

    Can you tell me what additionnal checks or config I need to make this work ?
    Did you change something or disable this feature in last versions ?

    Best regards,

    droop

    January 12, 2015 at 14:56 #9569

    droop
    Member

    I found out how to make it work again :
    ir-keytable -p lirc

    it sets enabled protocol to LIRC whereas default is RC-6.
    but it only works until next reboot, do you know how to have this setting permanent ?

    Best regards,

    droop

    January 17, 2015 at 08:33 #9582

    Warped Rudi
    Moderator

    You could play with /usr/bin/change-rc. It’s executed on each boot and it’s purpose is to modify the behaviour of the remote control.

    January 21, 2015 at 10:01 #9589

    droop
    Member

    Hello,

    Thanks, this solution will work for sure.

    Best regards,

    droop

  • Author
    Posts
Viewing 4 posts – 1 through 4 (of 4 total)

You must be logged in to reply to this topic.

Comments are closed.